Clipsal - Lighting, Batten Holder BC, Adjustable

Home ProductsLightingClipsal - LightingBatten Holder BC, Adjustable

Clipsal - Lighting, Batten Holder, BC, Adjustable WE

Item Number: 535-WE

With an adjustable base allowing you to angle the bulb, the Clipsal Bayonet Cap Batten Holder lets you position your light source exactly where you need it. The batten holder has a White Electric finish.



Qty UoM EAN Colour





Product or component type

BC lamp holder adaptor

Colour tint

white electric


Provided equipment

lamp holder|skirt

Device mounting


Eu rohs directive

Under investigation


Package 1 bare product quantity


Unit type of package 1


Number of units in package 1


Package 1 height

6.5 cm

Package 1 width

6.6 cm

Package 1 length

8.6 cm

Package 1 weight

74 g
Show all specifications

Frequently Asked Questions

hide show

Can PM5350 log data and send them ?

PM5350 does not have on-board data logging feature. 

The meter has Modbus serial port and can send data when requested via Modbus. 
However, PM5350 does not log data inside the meter.
Modbus Register Map PM5350 :

A data logger such as Com'X is required for data logging.
Refer to the catalogue in the link-


GeoSCADA, SCADAPack - What does System Error Code 1410 indicate

 The System Error Code -> 1410 on the controller status page of SCADAPack E Configurator indicates Low RAM battery. 


You will have to replace the RAM battery to clear this error. 

Replacing the RAM battery is discussed around page 141 onwards of the SCADAPack 535E Hardware Manual. This section also details the risks should the battery not be replaced. The Hardware Manual can be found at the following hyperlink:

Replacing the battery on a 535E.png
Schneider no longer supplies replacement RAM batteries. You can replace this battery with one of the following 3.6 V lithium batteries recommended by Schneider Electric when the rPAC reports that the RAM battery status is low and at the intervals recommended in the Routine Maintenance section.
· Tadiran TL-5186
· Omni Cell ER22G68
· Eve Energy ER22G68

After replacing the RAM batteries, kindly set the RTC to PC time and clear the system status code, from Transfer menu -> select Set RTU Time -> select Use local (PC) time and press ok.

Local on board RAM battery is monitored by binary system point 50207.