Pedestal, Stainless Steel, Suits 2, C2000 Series

Yes, however the initial transfer must take place serially using the Unitelway driver or direct transfer of the application to the PCMCIA memory card using a laptop computer with a PCMCIA slot. This is because the ModbusTCPIP protocol needs to be resident in the Magelis. Once the ModbusTCPIP protocol is resident in the Magelis, then transfer can be accomplished using the remote transfer option. The remote transfer option is located under the pull down menu for transfers then remote address.

Issue

The purpose of this resolution is to provide Advantys STB users with the means to determine current requirements
in their STB Island and help select which current sources are required.

The goal is to help simplify power component selection for an Island.

Product Line

Advantys

Resolution
Bus current requirements of STB Island modules and bus current supplying module capabilities are listed in
this document. There is also a field device load totalizer that may be used to determine the number of PDT
modules required.

After Island bus current requirements are totaled, If the NIM module bus current capability is exceeded, it may be augmented by the following current sources:

End of Segment - Beginning of Segment combinations. These cable linked modules are used when Islands
served by a single network communicating NIM are separated, or when additional bus current is required.
The BoS module serves as a new source of bus current.

A CPS2111 Auxiliary Power Supply can be added serially with I/O modules to extend the Island.

Just as an Island requires a NIM plus one or more STBPDTxxxx modules to supply field power, these bus current sources must also be followed in an Island configuration by one or more of these power distribution modules (PDM).