Clipsal - Motion Sensor Motion Sensor Load Correction Capacitor Allows 2 Wire Devices to be Used
Item Number: 31CAP
Datasheet
Specifications
Design
| Product brand | Clipsal |
|---|---|
| Product or component type | capacitor |
Physical
| Mercury free | Yes |
|---|---|
| Rohs exemption information | Yes |
| Environmental disclosure | ENVPEP1308010EN |
| Eu rohs directive | Compliant By Exemption |
Documents & downloads
-
All
-
Environmental Disclosure
-
End of Life Manual
-
Installation Instruction
-
Certificates (MSDS)
-
Declaration of Conformity (Sustainability)
Frequently Asked Questions
What is the difference between the 31Cap and 31LCDA?
Hide ShowThe 31CAP is a load correction device which consists of a "Capacitor only" to help 2 wire products achieve minimum load levels. The 31LCDA has circuitry built in to the device to enable it to correct minor compatibility issues found between dimmers and LED lights for example slight flickering when dimmed at a higher level.
31CAP - Increases minimum load.
For further information please visit https://www.clipsal.com/Trade/Products/ProductDetail?catno=31CAP
31LCDA - Assists with compatibility issues.
For further information please visit https://www.clipsal.com/Trade/Products/ProductDetail?catno=31LCDA
I am installing a 2-wire Dimmer, when should I be using a 31CAP or 31LCDA?
Hide ShowThe 31CAP and 31LCDA both have separate uses to resolve issues experienced with 2-wire Dimmers.
The 31CAP should be used when minimum load of the device is not being met, this is usually indicated by the load/light, that is controlled by the dimmer, by glowing when it should be off. Adding the 31CAP will increase the load and prevent the load/light from glowing in the off state. Depending on how far off minimum load you are more than one 31CAP may be required.
The 31LCDA should be used in instances where the load/light is flickering constantly, which indicates an issue with compatibility with the 2-wire dimmer used. The 31LCDA resolves these incompatibilities and flickering should then stop, if the flickering is reduced but still present you may need another 31LCDA to completely resolve. No more than 3x 31LCDA’s should be used on one dimmer.
Why does my 41E300PBUD2SM (Dimmer) leave my light glowing when the dimmer is off?
Hide ShowYou can then connect a 31CAP to increase the loading.