Quantcast

Clipsal MAX4 Mini Neutral link 140 A 500 V 10 hole with cover front wiring Black

Clipsal MAX4 Mini Neutral link 140 A 500 V 10 hole with cover front wiring Black

Clipsal MAX4 Mini Neutral link 140 A 500 V 10 hole with cover front wiring Black

Item Number: L10/35

Retail
$137.50
RRP (Inc. GST)

Datasheet

Barcode

Qty UoM EAN Colour
-
-
-

Specifications

Design

Product brand

Clipsal

Range of product

Blue Point

Product or component type

neutral link

Physical

[In] rated current

140 A

[Ue] rated operational voltage

500 V

Connector type

screw terminals

Number of poles

1

REACh Regulation

Free of Substances of Very High Concern above the threshold

EU RoHS Directive

Compliant

Mercury free

Yes

RoHS exemption information

Yes

China RoHS Regulation

Product out of China RoHS scope. Substance declaration for your information

Others

Number of Units in Package 1

1

Package 1 Height

56 mm

Package 1 Length

111 mm

Package 1 width

65 mm

Unit Type of Package 1

PCE

Cable cross section

35-35 mm²

Package 1 Weight

273 g
Show all specifications

Frequently Asked Questions

hide show

Is there an active link that can house a 35mm cable available?

Yes the part number is L10/35R

what tunnel sizes does the L10/35a have ?

 
 
3 x 9mm diameter to suit 35mm2 and 7 tunnels at 6mm to suit 16mm2
 
 

What are the part numbers for neutral and active links that take 25mm cable?

The part numbers are L11/25 for the neutral link and L11/25R for the active link.

Video: Battery Installation of APC AV Power Conditioners with Battery Back-Up

Issue:
How to install and connect the battery in a APC Power Conditioner with Battery Back-Up at first time start-up or following routine battery replacement.

Product Line:
APC AV Power Conditioners with Battery Back-UP
S20BLK
S15BLK
S10BLK
J15BLK
J10BLK

Environment:
All models and serial number ranges.

Cause:
Battery must be installed and connected for proper device protection during power outages and interruptions. This is most common upon initial set-up or following a routine replacement of an end-of-life battery.

Resolution:
In accordance with APC’s interpretation of U.S. Department of Transportation regulations, APC ships this device with the internal battery pack disconnected. The front bezel of the unit is also not attached to the unit when shipped. This procedure provides for connection of the battery when the front bezel has been prematurely installed onto the chassis. Connect the internal battery pack as follows:



1. Grasp the front panel at the sides (Figure 4), and pull the front bezel from the unit.



2. Push the Battery Wire Connector (Figure 5) into the hole located at the left of the Battery Pack. Ensure that the Battery Wire Connector is pushed into the hole and securely connected by gently pulling on the wire to see if it is attached to the connector.



3. Install the battery retaining bar.

4. Install the front Bezel (Figure 6), by aligning the four pins located on the back-side of the Bezel to the holes at the left and right sides of the unit. Gently push the front Bezel onto the unit.