elbow inspection pvc 32mm

Inspection Fittings - PVC, Inspection Elbows - White, 32mm

Catalogue Number: C244/32
elbow inspection pvc 32mm
RRP (Inc. GST)
Colour White Electric (WE)
  • White Electric 1 PCE


hide show
Product brand
Range of product
Series 244
PVC (polyvinyl chloride)
32 mm
Operating angle
90 °
80 mm
Environmental characteristic
chemical pollution resistance
AS/NZS 2053
Package 1 Weight
62.8 g
Package 1 Height
42 mm
Package 1 width
70 mm
Package 1 Length
83 mm
REACh free of SVHC
EU RoHS Directive
Pro-active compliance (Product out of EU RoHS legal scope)
Toxic heavy metal free
Mercury free
RoHS exemption information
China RoHS Regulation
 Pro-active China RoHS declaration (out of China RoHS legal scope)

Frequently Asked Questions

hide show

Can I get the 242/32 in orange?

Yes, the 32mm coupling is available in orange. The part number is 242/32-EO.

For further information please visit https://www.clipsal.com/Trade/Products/ProductDetail?catno=242/32


Video: How do I Setup a Magelis IPC to connect a Pelco Camera?

Is there an end cap available for the 4BB3 ?

The part number for end caps to suit the  4BB3 is 4BBTC3 ( set of 10 )
for more information on this product range please visit the Clipsal web site on the link provided

Do you have a 32mm inspection Tee conduit fitting with out the inspection hole?

No, unfortunately we only do the 246/32, 32mm, Inspection Tee with the inspection hole.

For further information please visit https://www.clipsal.com/Trade/Products/ProductDetail?catno=246/32

Can I use a single Altivar drive with 2 motors that are coupled to the same load if the RPM of the motors is different?

Can I use a single ATV71 drive with 2 motors that are coupled to the same load if the RPM of the motors is different?

Product Line:
All Altivar drives.

All models, All serial numbers.

Customer had a load sharing application with identical motors.  One motor failed and had to be replaced but an identical replacement was not available.  The RPM of the replacement motor does not match the RPM of the remaining original motor.

No, this is not recommended.  With both motors being powered from the same drive, they will both receive the same frequency.  The RPM rating of the motor states the number of revolutions per minute the motor will spin when powered with standard frequency power.  If the RPM does not match between motors then the motors will be turning at different speeds when both receive the same frequency power.  This will cause one motor to handle more of the load than the other.