683H

Aust 3 Gang Switch Horizontal

Catalogue Number: 683H
683H
Colour: White
Colour: Per UOM Std.
  • White 1 PCE

Specifications

hide show
Range of product
PDL 600 Designer Series
Product brand
Clipsal
Device presentation
basic element with full cover plate
Switch function
  • 1-way
  • 2-way
    • Actuator
      rocker
      Number of rocker
      3
      Device mounting
      flush
      Fixing mode
      by screws
      Local signalling
      without
      [Ue] rated operational voltage
      250 V AC
      Rated current
      20 A
      Marking
      without marking

      Documents & downloads

      hide show
      Filter items
      • All

      • Product Brochures

      • Technical Data Catalogues

      • Installation Instruction

      • Specifications

      • Certificates (MSDS)

      • Corporate Marketing

      Frequently Asked Questions

      hide show

      Is the 683 waterproof switches available with press mechs

      No, not available

      Looking for a switch for auto / off / on like the old 553 in a PDL 682VH plate

       You can use a PDL 100MPIR + PDL 617M3M/A + PDL 681M20 + PDL 683VH plate

      Can I fit 3 PDL USB mechs in a PDL 683VH plate

      Yes you can by using PDL683VH plate + PDL642MUSB x 3

      What is the dimensions for a PDL 683 3-Gang Switch ?

      Overall Dimensions: 118mm x 74mm
      Mounting Centres: 84mm

      Can the Altivar 58 unit use the same dynamic resistors as the ATV66, ATV16 and ATV18?

      Issue: Can the Altivar 58 unit use the same dynamic resistors as the ATV66, ATV16 and ATV18?
       
      Product Line: ATV58
       
      Environment: All
       
      Cause: N/A
       
      Resolution: Yes. Actual DB resistor used depends on the application. The installation guide for the drive shows the minimum Ohms value to be used. The wattage or continuous current rating of the resistor depends on mechanical considerations.
      The optional parts list shows the same DB resistor part numbers for the ATV58 as used with the ATV66.


       

      What is the ERR7 fault on Altivar ATV58 keypad display?

      Issue:   
      What is the ERR7 fault on Altivar ATV58 keypad display?
       
      Product Line:   
      ATV58
       
      Environment:  
      All
       
      Cause:  
      ERR7
       
      Resolution:   
      Probable Causes:
      Serial link time out error. The keypad display is not getting a response from the drive controller. If the keypad display is remotely mounted, electrical noise may be present. The port baud rate (tbr) may be set to 9600 bits/s.
      Corrective Actions:
      Cycle power on the drive controller. If the keypad display is remotely mounted, verify that the cable is properly shielded. Ensure that the cable is routed away from motor leads. See below menu 4 control for instructions for resetting the tbr parameter back to 19200 bits/s. If the problem persists, replace the control board on the drive controller with part number VX4A581U. An Ini fault may be displayed if the problem persists.