Ceiling Switch

White | Ceiling Switch

Ceiling Switch

Item Number: 573-WH

RRP (Inc. GST)



Qty UoM EAN Colour



Range of product

PDL 500 Standard Series

Product brand



Device presentation

basic element

Switch function



pull cord

Fixing mode

by screws

Local signalling


[Ue] rated operational voltage

240 V AC

Rated current

  • 8 AX, fluorescent lamp
  • 16 A
    • Marking

      without marking


      Package 1 Weight

      1 kg
      Show all specifications

      Frequently Asked Questions

      hide show

      How to use Com’X510 as a Modbus TCP Gateway for serial slave devices?

      1. Please refer to the details in the ‘Modbus TCP Access’ section in the Com’X510 User Guide .

      2. Please double check all the slave devices have been set with the same serial settings (Baud rate, Parity, etc.) as the Com’X510 ‘Modbus Serial’ settings (Settings > Communication > Modbus Serial.).

      3. Configure the Com’X510 ‘Modbus Gateway’ setting as follows.


      4. Please make sure ‘Enable Serial Modbus Broadcasts’ is enabled.


      5. Please note that the ‘Enable Modbus TCP/IP on Ethernet’ setting in the ‘Firewall Management’ section is also enabled for the required port.


      6. You can check and confirm the Gateway behavior by communicating to the slave devices using Modbus Tester and simply reading registers using the IP address of the Com’X and the Slave ID. Please see below example.


      What are the specifications for a PDL 573 pull cord ceiling switch ?

      Plate size:  66mm diameter
      Mounting Centres: 50mm
      Rated at 230V - 240V a.c.  16A resistive, 16A inductive   8AX fluorescent

      Is it possible to have an intermediate switch in Saturn Zen with an LED?

      It is possible to have 3 way switching iluminated by using 3x 60PBLs with one 600RM wired in the configuration below. Note: 
      Image also available in issue 71 pocketbook page O3.

      What is the difference between S33595 Full Function Test Kit and S33594 Hand Held Test Kit

      Product Line:
      Circuit Breaker Test Set

      HHTK - The S33594 Hand Held Test Kit will test the trip function of the breaker, and may be used for inhibiting ground-fault and thermal imaging, and enable zone-selective interlocking (ZSI) self-restraint during primary injection testing.

      FFTK - The S33595 Full Function Test Kit will test LSIG functions plus inhibit ground-fault and thermal imaging, and enable ZSI for primary injection testing.

      Additional details below: