White Electric | Junction Box, Miniature, with Cover and Three x Two Screw Terminal

No, we don't sell the lid for a 559/3 separately. You must buy the complete junction box.

A9C15913

651A-CARRIER
for more information on the 651A series please visit the Clipsal web site on the link provided
https://www.clipsal.com/Trade/search-results?q=651a

Solid and Cavity Brick Walls (Bracket Mounting)

Prepare wall by cutting hole 90 x 90mm for 56FA1, 90 x 190mm
for 56FA2, 90 x 285mm for 56FA3 and 190mm2 for 56FA4.
Mount bracket to exterior wall using any suitable fixing device i.e.
thrubolts, fibre plugs, etc.
Remove adhesive backing sheet from gasket and adhere to inner
surface of flange. Mount modules to bracket through flange.
Note: 1. For soft or porous brickwork we suggest adhesive
anchored fixing.
2. When mounting to brick ensure all mortar joints are
sealed with suitable caulking compound.

 

Panel Type Walls (Bracket Mounting)

Prepare wall by cutting hole as described above for solid and
cavity brick walls. Mount bracket to wall using suitable hollow wall
anchors. Adhere gasket to flange and mount modules through
flange to bracket.
Note: If possible mount bracket to building frame i.e. wooden
noggins and studs with suitable wood screws.

56FA2 is the part number of the flush surround to suit 56CV, one piece cover switched outlets. Surface mounted 56 Series Sockets, Switches and Combinations can be transformed into flush mounting equivalents using the 56FA Surrounds and Brackets. The surrounds can be used on various types of walls to ensure a neat installation, such as:
• a mounting enclosure (back box) in poured concrete
• a bracket on brick, brick veneer or panel walls.
The brackets provide the installer with a  practical method of flush mounting 56 Series accessories. Comprehensive installation instructions are supplied with all units.
56FA1, 56FA2, 56FA3 and 56FA4 Flush Surrounds contain a moulded flange, foam gasket and stainless steel mounting screws.
For further information, please visit https://www.clipsal.com/Trade/Products/ProductDetail?catno=56FA2

Over the coming months, the terminal connectors supplied with a number of Electrical Accessories will be changing. These changes are:
 

1. The screw type in the connector will suit either a No. 2 Philips Drive or a No 1 Square Drive screwdriver.

 

1. Terminal connectors will now be square wrapper design, ensuring reliable connection.

 

1. All connectors will now be supplied with single screw. This is fully compliant with AS/NZS3000:2007 as per clause (d) below from sub-section 2.9.4. for active, neutral and earth connections.

(d) a neutral conductor used as a combined protective earthing and neutral (PEN) conductor for protective earthing of any portion of an electrical installation, the terminal shall be of a type having—

1. two screws; or
2. one screw with an outside diameter not less than 80% of the tunnel diameter.

 
The terminal connectors being supplied have a screw diameter in excess of 80% of the tunnel diameter which means the single screw connectors can be used for active, neutral and earth connections.
 
The products supplied with new connectors are:

• 504/4
• 554/3
• 554/4
• 554J4
• 554C4
• 554J4B100
• HD554J4