Quantcast

White Mounting Clip

White | White Mounting Clip

White Mounting Clip

Item Number: 539-WH

Retail
N/A
RRP (Inc. GST)

Datasheet

Barcode

Qty UoM EAN Colour
-
-
-

Specifications

Design

Product brand

Clipsal

Range of product

Series 500/600

Product or component type

clip

Others

Accessory / separate part category

mounting accessory

Package 1 Weight

4 g
Show all specifications

Frequently Asked Questions

hide show

What is the replacement AC coil for CAD32 and CAD50 relay?

Issue:
AC coil replacement for CAD32 and CAD50

Product Line:
Relays

Environment:
Tesys CAD Control Relays

Cause:
Product selection

Resolution:
Volt = coil part number
12 = LXD1J7
21 = LXD1Z7
24 = LXD1B7
32 = LXD1C7
36 = LXD1CC7
42 = LXD1D7
48 = LXD1E7
60 = LXD1EE7
100 = LXD1K7
110 = LXD1F7
115 = LXD1FE7
120 = LXD1G7
127 = LXD1FC7
200 = LXD1L7
208 = LXD1LL7
220/230 = LXD1M7
230 595 21 LXD1P7
230/240 = LXD1U7
277 781 30 LXD1W7
380/400 = LXD1Q7
400 = LXD1V7
415 = LXD1N7
440 = LXD1R7
480 = LXD1T7
600 = LXD1X7
690 = LXD1Y7

 

If IEEE 519 is required, who enforces it? Citation concerns?

IEEE 519 is recommended practice standard and not really mandatory; Utility may ask this to be enforced;

What are the dimensions of the 533 batten holder?

The 533 batten holder has a base diameter of 90mm, overall lenght of 60mm and mounting centres of 50mm.

For further informatiom please visit https://www.clipsal.com/Trade/Products/ProductDetail?catno=533

 

How much weight can a 530 batten holder hold for a DIY pendant light?

The 530 batten holder can be used in a pendant situation.
However the 530 is normally attached to a lamp shade (or equivalent) where the lamp shade takes the weight.
 
The 530 according to standards needs to withstand 5nm of force which equated to about 0.5kg
 

What size cut out is required for the PDL 533 Panel Mounting Clip?

The clip requires a 30mm square hole as per the 600 Series/500 Series Brochure (PG 45).
Please see the brochure attached for more information.

What is the difference between Fire Mode (Function 52) and Force Mode (Function 53) in Altivar 21 Drive.

The difference between the Fire Mode (Function 52) and Force Mode (Function 53) is as follows:

In Fire Mode (Function 52) the Drive will run until it fails, any Fault and/or Stop command will not work. In this function the drive cannot be stopped unless power is removed.
 
In the Force Mode (Function 53) the Drive runs but critical fault and/or Keypad Stop will stop the drive.
 
The Critical faults are:
Over Current (OC), Overvoltage (OP), motor current sensor error (Err7), Under Voltage (UP1), Ground Fault (EF2), OCP and excessive torque boost fault (E-20).
 
 
Refer attachment for the list of faults.
Show More