White Electric | Grommet, Suit 2.5sqmm Ordinary Duty Flexible Cord with Clamp

Issue:
Getting CAD drawings for the ATV312 drives

Product Line:
Altivar ATV312 and ATV31

Environment:
All

Cause:
Cad drawings

Resolution:
Use the following link to the CAD Drawings Catalog.

https://www.schneider-electric.us/sites/us/en/support/product-support-resources/3d-cad.page


CTA-ID : 2061638

Issue:
What does a blinking E on the ATV21 or ATV212 display mean?
What does External Fault mean on the graphic keypad?

Product Line:
Altivar 21
ATV21
Altivar 212
ATV212
S-flex enclosed ATV21/ATV212

Environment:
All

Cause:
Flashing E on the display of the ATV21 or ATV212 drive.

Resolution:
The drive is in a faulted status, initiated by one of the following:
1) CMOd is set to 0 or 2, the drive is in remote mode and the keypad STOP button is pressed.  Since the drive is looking for a stop command from a logic input or serial communications, the STOP button is assigned to function as an E-STOP. (See page 87 in the ATV212 Programming Manual and attachment)

2) A logic input is assigned as External Fault, functions 11 or 45, and that logic input fault is activated.
To reset the fault, either cycle power to the drive or activate a logic input that is assign as Fault Reset, functions 10 or 55.


Video uses the ATV212 drive for demonstration purposes:


 

Issue:
Video: Automatic restart on the ATV21 / ATV212 drives

Product Line:
ATV21 and ATV212

Environment:
All serial numbers for ATV21 and ATV212

Cause:
Certain faults can be automatically reset after the cause has cleared.  The drive will then restart the motor.

Resolution: 
Set F303 to any value, from 1 to 10, indicating the number of attempts to clear the detected fault. 
By factory default F303 is set to 0. A value of 0 disables the feature.
If the fault clears, the drive will restart the motor if the run command is active.
If the fault does not clear after all attempts are made, the drive will require a manual reset.

The first clear is attempted 1 second after the detected fault occurs.  Each subsequent clear attempt adds 1 second to the time interval between attempts.

 




See the ATV212 Programming Manual, page 135 for further details.

In regards to the 5000CTC touch screen stuck in booting mode.

It's a known issue if you are touching the screen during the boot up process the CTC will fail to boot entirely and will appear to be stuck in the booting up mode.

Our advise is once the screen is powered ON or soft reset, is to not touch the screen until it's fully booted and connected to C-Bus indicated in the top left corner.

If replacing just the slave rotary (DCCAL31SROT) then no but if replace the master unit (DCDAL31M2PB)  that the slave is connected to then yes.

The master switch can be use to control the light without the rotary slave only if the master is program with the same group/address.

To identify if the C-Bus Network  interface is being used elsewhere,

• Type the CNI IP address into any Web Browser 'address bar' then press [enter]
• This shows if the interface is being used elsewhere as per image below 'C-Bus Status:'