Quantcast

Solid Fittings - PVC, Converting Adaptors, 25mm Screwed to 1 Inch Plain

Grey | Solid Fittings - PVC, Converting Adaptors, 25mm Screwed to 1 Inch Plain

Solid Fittings - PVC, Converting Adaptors, 25mm Screwed to 1 Inch Plain

Item Number: 236/25S1-GY

Retail
$15.25
RRP (Inc. GST)

Datasheet

Barcode

Qty UoM EAN Colour
-
-
-

Specifications

Design

Sustainable offer status

Green Premium product

Product brand

Clipsal

Range of product

Series 236

Physical

Mercury free

Yes

Environmental Disclosure

ENVPEP100802EN

REACh free of SVHC

Yes

REACh Regulation

Free of Substances of Very High Concern above the threshold

China RoHS Regulation

 Pro-active China RoHS declaration (out of China RoHS legal scope)

EU RoHS Directive

Pro-active compliance (Product out of EU RoHS legal scope)

RoHS exemption information

Yes

Toxic heavy metal free

Yes

Connector type

thread connector

Length

40-40 mm

Standards

AS/NZS 2053

Material

Material

PVC (polyvinyl chloride)

Others

Number of Units in Package 1

1

Package 1 Height

30 mm

Package 1 Length

40 mm

Package 1 Weight

11 g

Package 1 width

30 mm

Unit Type of Package 1

PCE
Show all specifications

Frequently Asked Questions

hide show

Video: What causes an StF fault on an Altistart 22 Soft Starter?

Issue:
Troubleshooting StF Fault on Altistart 22

Product Line:
ATS22 Soft Starter

Environment:
All models

Cause:
The StF fault means the starter has exceeded the maximum start time setting, tLS, in the SEt menu.  

Resolution:
tLS needs to be set higher than the ACC time.  
For example:  If ACC (ramp up time) is 10 seconds, then set the tLS max starting time to 20 seconds.

If ILt current limit is too low, the motor may not reach full speed within tLS limit.
Mechanical problems on the load may prevent the motor from reaching full speed within tLS limit.
See page 51 in the ATS22 User Manual:



The following video is a guide for troubleshooting the StF fault code, indicating a longer than expected start-up time, on the Altistart ATS22 soft starter by adjusting the tLS (maximum start time in seconds) and ACC (ramp up time) parameters under the SET menu. tLS must be set higher then the ACC time value.