Volume control for SONOS and PUSH is not working?
FAQ000220657
30 September 2021
Volume control for SONOS and PUSH is not working?
Note: These recommendations or suggestions below are assuming you are familiar with programming PUSH Controls, have the Project Editor Software & have the original project file (.bwe).
I. “Break-out” volume control is not updated
Symptom: “break-out” volume control is not updated to show the current volume level and mute statePlease make sure that you are using module version 1.70 or above. Also, make sure that the IP address of the zone is correct. You can check this from the “User Settings” tab.
II. Unable to Switch to Line-in / TV Line-in
Symptom: unable to switch Sonos Amp to Line-in or Sonos Playbar to TV Line-inTo switch line-in on Sonos Amp, make sure that you are using the setLineIn() function. And to switch TV line-in on Sonos Playbar, make sure that you are using the setTVLineIn() function. They are not interchangeable.IMPORTANT: the MAC address must be specified and it must be all uppercase.
