Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How to install a control wire into a Masterpact NW/NT push in connector

    Issue:
    How to install a control wire into a Masterpact NW/NT push in connector

    Product Line:
    Masterpact NT and NW

    Resolution:
    Place a small flat screwdriver into the square hole (do not pry up or down), then insert control wire into the round hole just above the screwdriver. Then remove the screwdriver. The acceptable wire size is 22-14 AWG(.4-2.5mm^2). Strip length is .3 in. (8mm).

     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance