Discover our Clipsal Smart Home packages as seen on The Block 2018

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How to setup a Tesys LTMR to talk to a Magelis over E/IP?

    Issue: Looking for a guide that describes how to setup a Tesys LTMR to talk to a Magelis over E/IP.

    Product Line: Magelis (XBTGT, XBTGH, XBTGK, HMIGTO, HMIGTU, HMISTO, HMISTU),  Tesys LTMR, Vijeo Designer

    Resolution: Attached is a guide on how to setup the LTMR to talk to an Allen Bradley PLC over Ethernet/IP. These are the same steps taken when setting up the LTMR to talk to a Magelis. Once the LTMR is setup, you would need to use the Generic Ethernet/IP (explicit) driver in Vijeo Designer.  This driver can be found under the Generic Drivers Manufacturer in the New Driver dialog. From there, you would need to setup some variables in Vijeo Designer to get/set the parameters from the LTMR. Be sure to use the "Vendor Defined" class and set the instance according to the instances available on the LTMR.On pg 22 and forward of the PDF, there are some instances listed

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance