Discover our Clipsal Smart Home packages as seen on The Block 2018

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    ClearSCADA: Multiple Containers in ClearSCADA 2017 R2

    The StartupConfiguration.xml file used to configure multiple ViewX containers has changed in ClearSCADA 2017 R2.  The StartupConfiguration file format that was used for ClearSCADA 2015 R1, ClearSCADA 2015 R2 and ClearSCADA 2017 must be changed in order to run multiple containers in ClearSCADA 2017 R2.  Below are the details:

    Information Regarding Multi-Monitor Setup in the ViewX Help:  May be found in:

    System Administration | Client Administration | Launch a ViewX Client on a Multi-Monitor Setup | Configure a Multi-Monitor Setup | Startup Configuration File


    Note shown on the ViewX Help opening page in ClearSCADA 2017 R2:



    StartupConfiguration.xml example 1:

    The following StartupConfiguration.xml file is an example of a 2 monitor configuration with the homepage and alarm banner shown on both monitors.



     

     
    AlarmBannerPersistSettings="true" AlarmBannerDisplayState="DockedBottom" />
     
    AlarmBannerDisplayState="DockedBottom" />
     

     

     
    Monitor1_homepage
     
    Monitor2_homepage
     

     



    StartupConfiguration.xml example 2:

    The following StartupConfiguration.xml file is an example of a 2 monitor configuration with the homepage shown on both monitors only (i.e. no alarm banner).



     

     

     

     

     

     
    Monitor1_homepage
     
    Monitor2_homepage
     

     




    (Older StartupConfiguration.xml example)

    The following StartupConfiguration.xml file is an example of the file used in ClearSCADA 2015 R1, ClearSCADA 2015 R2 and ClearSCADA 2017 (Initial Release).  Notice the differences between this file and the files above which include:
    • removal of the 'InterfaceMode' clause
    • a change to the 'AlarmBanner' syntax
    (The affected lines of code have been highlighted below.  This is the equivalent file to Example 1 above.)



     
    AlarmBannerWindow="Right">
     
    InterfaceMode="SingleDocument" DisplayMode="FullScreen"/>
     
    InterfaceMode="SingleDocument" DisplayMode="Restored" />
     

     

     
    Monitor1_homepage
     
    Monitor2_homepage
     

     

     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance