in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Powerhouse Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What is the behavior of the FPI if the parameter cross-country fault detection is disabled?

    • This option is used to enable detection of "double" fault currents, i.e. 2 simultaneous phase-to-ground faults on 2 phases and at 2 different locations on the network.
    • In case of double fault on 2 different locations of the network, the 2 directions will be indicated.
    • In all cases this generates 2 phase faults. With this option the cross-country fault alarm will be set in addition to the phase faults.
    Note: cross-country fault detections are only available on instance 3 of a zero sequence fault (in ammetric fault detection).
    This case should not be confused with what is called "double fault" in France, which is referring to 2 faults in sequence
     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance