Discover our Clipsal Smart Home packages as seen on The Block 2018

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How to change the IP address through ION Setup 3.0 for ION meters?

    Issue
    How to change the IP address through ION Setup 3.0 for ION meters?

    Product Line
    ION meters

    Environment
    ION Setup 3.0

    Cause
    Would like to change the IP Address of an ION meter via ION Setup

    Resolution
    There are two methods to change the Network Settings of an ION meter through ION Setup

    Method 1: If changing one parameter (i.e. IP Address), this can be done through the Setup Assistant.

    Open ION Setup 3.0 and connect to the ION meter.

    In the Setup Assistant, navigate to the Communications folder then Network settings.

    Under the TCP/IP tab click on the parameter 'IP Address' then click Edit.

    New window will open (enter unit password, default = 0) to Enter IP Address.

    Enter new IP Address, then click OK. Device IP address is now changed.



    Method 2: If changing multiple parameters (i.e. IP Address, Subnet Mask, and Gateway), this can be done through the Ethernet Communication Module in Advanced Mode

    Open ION Setup 3.0 and connect to the ION meter.

    In Setup Mode hold "Ctrl" and left-click ION meter.

    Navigate to Comm Modules and open Ethernet module.

    Navigate to Setup Registers tab and click on the parameter to Edit.

    After parameters are Edited, click Send to send the changes to the ION meter.

    Notes:
    • After clicking ok it will attempt to reconnect Ethernet connection ... this may take a few minutes. 
    • Make careful note of your method of communication with your device. Making communications changes to the port by which ION Setup is connected to your device may cause ION Setup to lose communication with the device
    • Please refer to ION Reference, Communications Module pages 87 to 96, for detailed information about the Inputs, Setup Registers, and Output Registers.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance