Discover our Clipsal Smart Home packages as seen on The Block 2018

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Video: How to download the log and configuration files from a 2nd generation rack PDU unit by using a USB flash drive ?

    Issue
    This FAQ document provides instructions on how to download the log, configuration and debug files from a 2nd generation rack power distribution unit's (PDU) network management card (NMC) by using a USB flash drive.


    Product Line
    • 2G Metered/Switched Rack PDUs (AP84XX, AP86XX, AP88XX, AP89XX).

    Environment 
    • All serial numbers
    • Firmware revision v6.5.2 and higher

    Cause
    • New Firmware functionality was implemented to allow for a quick and user friendly way to download the log, configuration and debug files from a PDU by using a USB drive connected to the NMC's USB port.
    • The log, configuration and debug files may be required for review by the technical support team.

    Resolution
    To download the log, configuration and debug files from a PDU by using a USB flash drive follow the steps explained below:
    1. Insert a USB flash drive into the USB port on the rack PDU NMC. Before performing this step make sure the USB drive is formatted in FAT32.
    2. Scroll to the Log to Flash option on the display and press the Select button.
    3. Press the Select button again to export the files to your USB flash drive.
    NOTE: If a debug.txt file or dump.txt file does not exist on the Rack PDU, they will not be downloaded to the USB flash drive. These files are only created upon an unexpected system crash or a NMC reset and are for technical support use only.



    The log, configuration and debug files downloaded from the PDU NMC should look similar to the example below:



    Please see FAQ FA156131 for additional ways of downloading the log, configuration and debug files from the PDU NMC.

     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance