Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How do I setup my ATV630 and ATV930  Process drives to connect to Somove using Ethernet?

    How do I set up Somove over Ethernet on the ATV630 drive?

    Product Line:
    Altivar 630 Process Drives


    Customer needs to program/control the drive over a network

    Step 1 
    Need to find your PC’s Ethernet IP addressing information:
    In your Windows search box (in the Start menu if using Windows 7)
    Type ‘cmd’ enter - Command Prompt window opens 
    Type ‘ipconfig’ and press Enter
    Note the IP address, Subnet Mask, and Default Gateway of your PC 

    Step 2
    Power up the ATV630 drive 
    Using the HMI (keypad), from the main menu, go to the menu 6 Communication and press OK
    Highlight "Comm parameters" and press OK
    Scroll down and highlight "Embd Eth Config" and press OK
    Set IP Mode Ether. Embd to ‘Fixed’
    IP address needs to be the same as your PC except change the last octet to another number not already being used by another machine on your network (ex: your PC= and the drive=
    Set the ‘Mask’ to match your PC’s Subnet Mask (ex:
    Set the ‘Gateway’ to match your PC’s Default Gateway (ex:

    Step 3
    Open your SoMove software 
    On the left-hand side of the SoMove window click “Edit Connection / Scan”. 
    At the top left of the Scan Result window click “Modbus TCP”
    At the top right of the Scan Result window click the Advanced Settings button, which looks like a gear
    Choose the Scan tab at the top of the Advanced Settings window
    Enter your Drive’s IP address leaving the last octet as 0 and enter the last octet digit in the single scan box. 
    Example: 192. 168.1.0 
       Scan configuration: Single (checked) = 6
    Click Apply and click OK. (You may have to scroll down and to the right to see these)
    In the Scan Result window click “Scan Network” in the lower-left-hand corner to scan for the drive 
    Once your drive is discovered, double-click on it to begin working with it

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance