Discover our Clipsal Smart Home packages as seen on The Block 2018

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How to prevent the Windows "Enable Location Services" to show up when starting ViewX

     DISCLAIMER

    The example below is intended to demonstrate one or more features or methods and is presented as a configuration example only. Schneider Electric assumes no liability for the use or application of this example or any portion thereof.


     Starting with ClearSCADA 2017,  location services are supported by ClearSCADA clients (ViewX, WebX, CS Mobile).
    The end user may want to disable such services in Windows but, if not done properly, ViewX will still show a message like the following every time it starts:


    A common mistake is to go to Windows 10 Settings > Privacy > Location and just set the "Location service" switch to "Off" and still leaving the "Location  for this device "on":




    The right procedure would be clicking the "Change" button and setting the "Location for this device " to off:


    This setting will prevent the popu message to show up when ViewX starts.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance