Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Temperature Sensor not detected on an AP9631 that was pre-installed in a Symmetra

    An issue has been identified with AP9631's that come pre-installed in a single phase Symmetra unit - when connecting the temperature sensor to either UIO port, the NMC web UI will show either "Communication Loss", or will show a temperature sensor is connected, but not give any temperature reading:

    Product Line
    • Network Management Card 2 - AP9631

    AP9631 models that shipped preinstalled in a Symmetra - affected date range is 5A1641 and newer

    These NMC's have an issue that does not allow them to see exactly how many UIO ports they have, which causes this behavior. Other UIO accessories, such as the AP9610 dry contact accessory, will also not work. The NMC will function as expected in all other ways, this issue only affects the UIO ports.

    This issue has been resolved in firmware with AOS v6.5.0+. Upgrading the firmware will immediately resolve the problem. The latest revision of firmware can be found on, or available via the Data Center Expert (DCE) catalog.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance