Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How often the PwrModbus driver checks for new waveforms in PowerSCADA Expert

    Issue
    Depending on the volume of waveforms, the user may want to change the frequency of uploading waveforms for better performance.

    Note: This applies to PM, CM, and Sepam

    Product Line
    PowerSCADA Expert 8.2, PSE 8.2 (applies to v7.4 and newer)

    Environment
    Computer Setup Editor (INI parameter)

    Cause
    Contolling the frequency of waveform uploading in PSE.

    Resolution
    *Warning: This article contains information about editing the INI file. Improper changes can damage the system performance. Always backup the INI file before making any changes.*

    The parameter WaveformCheckTime defines the time the driver will wait between checking for new waveforms.

    Parameter type: seconds
    Default value: 30


    This parameter has to be added in INI file.  In the example below the system checks for waveforms every 60 seconds:

    [SEPAM40.MYCLUSTER.PORT_1.DEVICE_A]
    WaveformCheckTime 60

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance