Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Is it possible to disable phase loss detection function in ATS48?

    Disabling the phase loss detection function in ATS48 is only possible only through Somove. The parameter cannot be disabled through graphic terminal. However it is not recommended to disable this function especially in following circumstances:

    - When using ATS48 for its typical applications
    - When using a bypass contactor unless exterior detection methods exist

    For disabling phase loss detection, go to ATS48 parameters in Somove, go to Advanced protections, search for parameter PHP, click on the current value and a warning will appear, press Ok and change the current value to Off. 

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance