Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How to remotely disable Sag and Swell alarming on a PM8000 power meter.

    Issue
    The PM8000 meter may have been improperly configured when originally setup causing nuisance alarms.

    Product
    PM8000 series

    Environment
    ION Setup
    Power monitoring


    Cause
    The PM8000 series meter alarms on Sags and Swells for current and voltage. In the event this needs to be disabled a remote method may be preferred.
    Alarms may include but not limited to: "DAN 6 exceeded"  or any variation of module numbers. 


    Resolution
    This method can be used for any of the modules under the Disturbance analyzer module 
    1. Open ION setup 
    2. If connecting in single device mode click exit button and when prompted to connect to another device, select no. In the left hand panel, hold control and click on Ethernet Device
    3. If connected in power user mode and the device is not already added , follow instructions in ION Setup User guide to add a site and device. 
    4. Once the device is available in the menu. Hold Ctrl key while left clicking the pm8000 device added.
    5. Locate "Disturbance analyzer modules" and left click
    6. To disable the current swell alarm double click "current swell" 
    7. Under Setup registers, select "DAN6 Enable" and click on the edit button.
    8. In the drop down menu select "disabled" and click Ok.
    9. Click send button.
    10. To disconnect from ION setup click File and then Exit.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance