in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Powerhouse Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Video: How to program an ATV320 for 3 wire control?

    Issue:
    Programming an Altivar ATV320 for 3 wire control

    Product Line:
    Altivar 320, ATV320

    Environment:
    All

    Cause:
    Programming, setup

    Resolution:



    From main menu,
    Enter on dial to go to CONF and enter.
    Go down to FULL and enter.
    Go down to I_0- and enter.
    Set TCC for 3C for 3 wire control.  This will require the enter key(dial) to be pressed for 3 seconds.
    In 3 wire control mode, DI1 is normally closed momentary stop and DI2 is normally open momentary start.
    If DI1 is not made the drive will display NST.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance