in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Powerhouse Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Video: How to program an ATV320 for 2 wire control?

    Issue:
    Programming an Altivar ATV320 for 2 wire control?

    Product Line:
    Altivar 320, ATV320

    Environment:
    All

    Cause:
    Setup, programming.

    Resolution:



    From main menu,
    Enter on dial to go to CONF and enter.
    Go down to FULL and enter.
    Go down to I_0- and enter.
    Set TCC for 2C for 2 wire control.
    Set TCT to LEL instead of TRN for level control.
    In transition mode, the drive will need to be powered up before a run command is given.
    In level mode (LEL), the drive logic DI1 has a state of 0 or 1.  If the run command is given it will run upon power up.
    If the run command is not there the drive will wait for one in RDY status.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance