Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How do I set up an ATV12 to use the dial on the front as a speed reference

    Issue:
    How do I set up an ATV12 to use the dial on the front as a speed reference

    Product Line:
    Altivar 12, ATV12

    Environment:
    All

    Cause:
    N/A

    Resolution:
    How do I set up an ATV12 to use the dial on the front as a speed reference

    To set up the drive to give speed control via the dial on the front:

    Firstly make sure that the drive is in REMOTE Configuration mode i.e. the three LED’s to the left of the display are not flashing in sequence. 

    If they are, to get back to REMOTE press the MODE button for 3 seconds and then follow the sequence below:
    Go to Configuration Mode – My Menu
    Down to Reference channel 1 (Fr1) press the center of the JOG DIAL (ENTER)
    Then set that to A1U1
    Press the escape button until rdY appears.
    You can then run the drive by the run and stop buttons on the front of the drive.

    To do this Press the run button
    Then press the center of the dial  reF appears
    Press the center of the dial again 0.0 appears
    Then by rotating the dial the speed will increase (the display is a % of the difference between LSP and HSP)
     If the start signal is given via a digital input LI*
    In the Full Menu (FULL)
    Control Menu CtL- and press the center of the JOG DIAL (ENTER)
    Go to Channel Configuration (CHCF) and press the center of the JOG DIAL (ENTER)
    Then Separate mode (SEP) and then Command Channel 1 (Cd1) and enter
    Make sure it is set to terminals (tEr)
    Press the escape button until rdY appears.
    Start the drive via the start button.
    Then press the center of the dial reF appears
    Press the center of the dial again 0.0 appears
    Then by rotating the dial the speed will increase (the display is a % of the difference between LSP and HSP)
    This setting will remain active until the supply is removed to get back to it just repeat the pressing of the dial.
     
    To monitor the Frequency or anything else go to reference mode.
     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance