Discover our Clipsal Smart Home packages as seen on The Block 2018

in location

Near Me
OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
1 Near Me
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location
    slider image 1

    FAQ

    Trade > Support & Downloads > Frequently Asked Questions > Frequently Asked Questions

    Back

    Why is Event Notification Module (ENM) 8.3.X installation failing at Registering Service Manager?



    Issue:
    The Event Notification Module (ENM) 8.3.X Installer fails the "Registering Service manager" as shown below.
    The SE Server manager Host service will not start if this issue is detected by the installer.



    It will continue with the installation and stop with Unsuccessful Configuration
    as listed on the screen shot below.



    Product Line:
    Event Notification Module

    Environment:
    Event Notification Module Installation

    Cause:
    The Registering Service Manager TimedOut during the installation and will not allow
    the SE Server Manger Host service to start.

    Resolution:
    The ENM installer fails the "Registering service manager" step, but all components are installed successfully.
    The step failed because ENM’s SE Server Manager Host service could not be started due to a port conflict between it and another service called LLWecSvc.exe.
    The SE Server Manager Host service is a peripheral service that does not have to be started for a successful installation.
    However, it does need to be running during run time of ENM.  When running it allows ENM's core services to be reset from the ENM Configuration web page.

    Go to Control Panel/Administrative Tools/Services and stop the LLWecSvc.exe service.  
    This now allows SE Server Manager Host service to be started.
    Choose Try Again on your ENM installation.  The installation will pick up again and complete without any warnings this time.
    The LLWecSvc.exe service can then be started back after the installation since it will pick a different port.


    More Information on the LLWecSvc.exe service
    This LL WecSvc.exe service is under TIBCO LOGLOGIC LESSO ENTERPRISE
    LOG COLLECTOR from LogLogic.





     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance