Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What is the cause for error 7340 on Lexium 32?

    Error 7340 is triggered when the drive cannot read the absolute position of the motor's encoder.

    The cause for this can be one or any of the following.
    Faulty wiring from the drive to the motor encoder.

    Electrical noise on the encoder signal caused by EMC.  Check for proper grounding of motor, proper grounding of motor power cable at drive and proper grounding of drive.  
    Do not route encoder cable near devices which create EMC.
    Do not route encoder cable parallel to the motor power cable.  
    Do not coil excess encoder cable. Excess encoder cable should be bundled in a zig-zagged pattern.

    Faulty encoder within motor.
    If encoder cable is not at fault and not routed near sources of electrical interference replace motor as final step.


    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance