Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Configuring Ethernet Communications on SCADAPack 535E

    The following procedure describes how to configure an Ethernet communications link between Eth1 on the rPAC and the SCADAPack E Configurator computer.

    To Configure an Ethernet Communications Link

    1. Plug the USB cable from the computer to the USB port of the SCADAPack 535E to write configurations.
    2. Using a CAT5 UTP cable, connect Eth1 on the rPAC to a switch, a hub, or a wall outlet for your LAN.
    3. Confirm that the SCADAPack E Configurator computer is also connected to the LAN.
    4. If the SCADAPack E Configurator software is not already running, launch it by selecting Start > All Programs > Schneider Electric > SCADAPack E > SCADAPack E Configurator and choosing your rPAC.
    The SCADAPack E Configurator main window opens as shown below.

    SCADAPack E Configurator Main Window
    1. In the SCADAPack E Configurator software, expand the TCP/IP folder then select the TCP/IP property page.

    SCADAPack E Configurator TCP/IP Property Page
    1. Enter the IP Address and Subnet Mask obtained from your network administrator.
    2. Then Write the configuration to the RTU and wait for the RTU to restart.


    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance