in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Powerhouse Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How can one setup ramp switching on the ATV630 Process drive?

    Issue:
    How can one setup ramp switching on the ATV630 Process drive?  

    Product Line:
    ATV630, Process

    Environment:
    All

    Cause:
    dual ways of ramping up to full speed.

    Resolution:
    Go into Complete settings under drive menu.
    Go into Menu 7.31 Generic functions, Ramp switching
    There is 2 ways of doing ramp switching.  One way is using frequency threshold and the other is using a logic input to switch ramp.
    Ramp 2 thd (FRT) is where you would assign a frequency for second ramp to take over.
    Ramp Switch Assign (RPS) is used if a logic input is preferred to be toggled for the second ramp to take over.
    The first ramp is followed by acceleration and deceleration parameters.
    The second ramp is followed by acceleration 2 and deceleration 2 located under Ramp switching submenu.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance