Discover our Clipsal Smart Home packages as seen on The Block 2018

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Is it possible to configure the PM800 series meters to only reset Min/Max values manually?

    Issue:
    A customer would like to change the Min/Max reset behavior on a PM800 series meter from the default monthly time interval to only on a manual basis.

    Product Line:
    PM800 series meters

    Environment:
    PM810 / PM820 / PM850 / PM870

    Cause:
    By default the Min/Max values for the PM800 series meters are configured to reset on a monthly basis.

    Resolution:
    Register 1443 is the Min/Max Configration register, to NOT allow Monthly Min/Max resets, that register must be set to a zero (0).

    if Bit 0 = ‘1’ the Present Month Min/Max is copied to the Previous Month Min/Max at 12:00:01 AM of the new month.

    To set register 1443 to 0 perform the following modbus register writes below.

    1) write value 9020 to register 8000 
    2) write value 0 to register 1443
    3) write value 1 to register 8001
    4) write value 9021 to register 8000

    These writes can be performed either through the front panel of the meter following the register write instructions on page 26 of the PM800 User Guide, or using Modbus Tester.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance