Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    PME 8.1 Install fails at "Configuring Web Framework"

    PME 8.1 installer fails at the step Configure Web Framework. 

    Note: There can be many different reasons why this step can fail. This article covers two possible reasons and resolution to these specific issues.

    Possible Reason 1:
    Verify that port 23102 is not blocked by the Windows Firewall. If this port is blocked, the PME installer will fail at the 'Configuring Web Framework' step so it needs to be unblocked. If this port is not blocked, proceed to 'Possible Reason 2'.

    Possible Reason 2:
    To determine if this article is relevant, perform the following:
    1) Open a command prompt and navigate to [PME install folder]\Applications\bin\
    eg. CD "C:\Program Files (x86)\Schneider Electric\Power Monitoring Expert\Applications\bin\"
    2) Execute the following command: ConfigServiceTool.exe factory "C:\Program Files (x86)\Schneider Electric\Power Monitoring Expert\Applications\Configuration\SharedWebFrameworkConfiguration.ini"

    The output of this command will return the following error:
    "Could not load the service inventory from web service: There was no endpoint listening at http://[Server Name]:23102/CoreServicesHost/Inventory/InventoryService that could accept the message."

    Power Monitoring Expert 8.1

    ApplicationModules ProviderEngineHost Service is not started

    Note: There can be many reasons why the ProviderEngineHost Service cannot start. For this article to be helpful, the following message will be seen in the Windows event log:

    ProviderEngineHost@[Server Name] Failed to load retry settings from application's config file.  The 'DbProviderFactories' section can only appear once per config file.

    *Warning: Take backups of any files prior to modifying them. Ensure the backups are in a location that will not be overwritten (i.e. the Desktop).*

    1) Open the following files with a text editor such as notepad
    2) Search for     ( may also be )
    3) Remove the line ""from the config file
    4) Start the ApplicationModules ProviderEngineHost Service if not already started
    5) Re-run the installer configure mode.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance