Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What can cause the Altivar 32 to fault on an Output Phase Loss?

    What can cause the ATV32 to fault on an Output Phase Loss?

    Product line:
    Altivar 32, ATV32

    All serial numbers for Altivar 32, ATV32

    Loss of phase/low current


    OPF1 is the detection of the loss of one output phase between the drive and the motor. 
    OPF2 is the detection of the loss of all three phases between the drive and the motor.

    - Confirm the motor settings are correctly entered into the drive Motor Control (DRC) menu
    - Check the wiring connections between the drive and the motor.  If there are any disconnects or junctions, check that the disconnect is closed and junction connections are secure.
    - If the motor is undersized for the drive HP rating, the drive may trip on phase loss due to low current detection, causing the drive to believe a phase is lost. 
    - Confirm the drive is working properly by disconnecting the motor leads, setting Output Phase Loss (OPL) to No, run the drive and check for equal voltage output, phase to phase.
    - If using an output contactor, set Output Phase Loss (OPL) to Output Cut (OAC)

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance