Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What can cause the ATV12 to show OLC?

    What can cause the ATV12 to show OLC?

    Product Line:
    Altivar 12

    All models

    Customer is doing 6 cycles per minute (start/stop) and noticed that after 3 cycles the drive will show "OLC"

    OLC is process overload.
    Check the process and the parameters of the drive to be in phase.
    Go to I_O- menu:
    Parameter tOL is the Application Overload time delay, adjustable range 0-100sec.
    Parameter LOC is the Application Overload threshold, adjustable range 70-150% of Motor rated current nCr.

    This function can be used to stop the motor in the event of an application overload. This is not a motor or drive thermal overload. If the motor current exceeds the Application Overload threshold LOC, an Application Overload time delay tOL is activated. Once this time delay tOL has elapsed, if the current is still greater than the overload threshold LOC -10%, the drive will stop running and display OLC Process overload.
    Overload detection is only active when the system is in steady state (speed reference reached).
    tOL = 0 will disable application overload detection.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance