Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Can I enable a Lexium SD328 stepping motor drive if the motor is not connected?

    Yes, it is possible to enable the SD328 drive without a motor connected.
    This can be done if you wish to test communication capabilities to the SD328.
    However, this will result in error code 5600 (missing motor phase) if the drive is enable

    Reading and writing of commands via the fieldbus can be tested without a motor connected to the SD328
    The drive will not be damaged if enable without a motor connected, but also, testing for motion will obviously not be possible if there is no motor connected.

    Note: Do not under any circumstance disconnect the motor cable while the drive is powered or enabled!  Doing so may result in drive damage.
    Only disconnect motor cable from stepper motor drives when the power is removed.


    Rev 9-18-17

     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance