in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Powerhouse Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Video: How to install an Ethernet Communication Card (ECC21) in a CM4000 Meter

    Issue
    Installation procedure for a CM4000

    Product Line
    ECC21
    CM4000
    CM3000

    Environment
    Installation

    Resolution
    *Warning: Installation and maintenance of this device should only be performed by qualified, competent personnel that have appropriate training and experience with high voltage and current devices. Failure to follow the instructions / warnings in the Meter Installation Guide can result in permanent damage to the meter, severe injury or death.

    This video is purely for demonstrational purposes.  When performing this procedure, a qualified person shall wear protective PPE gear rated accordingly for your electrical system.


    Before you begin:
    1. Turn off all power to the circuit monitor and the equipment in which it is installed. Be aware that the circuit monitor may be connected to a separate power source derived from the equipment in which it is installed.

    2. To turn off power to the circuit monitor:
    a. Disconnect the metered voltage either by removing the fuses from the potential transformer (PT secondaries) circuits or by turning off the voltage disconnect switch.
    b. Short circuit the current transformer (CT) secondaries to remove the metered current.
    c. Turn off the control power and any power sources to the auxiliary inputs and outputs.
    d. Turn off power to any option cards already installed in the circuit monitor.
    e. Always use a properly rated voltage sensing device to confirm that power is off.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance