Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What can cause the ATS48 soft starter to start and stop and start and stop?

    Issue:
    What can cause the ATS48 soft starter to start and stop and start and stop?

    Product Line:
    Altistart ATS48  and 48U enclosed

    Environment:
    All

    Cause:
    They start the soft starter but it drops in and out, and will not stay started

    Resolution:
    Check your Run, Stop +24vdc connections.  Remove the wires from +24vdc, and check the voltage with your meter.  If the voltages check out ok, then reconnect your end customers wires to see if the voltage drops down.  If the voltage is dropping down, then they have something in their control circuit that had caused the voltage to drop below the run threshold point.  Suggest maybe, adding an interposing relay to mount close to the Soft starter, and switch the +24vdc to run stop this way.   Avoid long cable runs off the +24vdc signal to prevent the voltages from dropping down.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance