Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How do you program the ATV61 or ATV71 drive to start running on power up with mains power?

    How do you program the ATV61 or ATV71 drive to start running at full speed when input power is turned on? 

    Product Line:
    Altivar ATV61 and ATV71 


    Needs the drive to start up and run at full speed when they power up the drive.

    Programming the drive as below:
    Menu 1.5 [Input/Output Config]
    Change 2 wire type to Level
    Menu 1.1 [Simply Start]
    Set Low speed to 60hz for full speed.  
    NOTE: if you want the drive to start on power up but need it to follow an analog or communication setpoint then set Low Speed and High Speed to your operating range.
     Wiring on the ATV61 or ATV71 drive. 
    Jumper +24vdc to LI1 to always have the run command present, or wire your Normally open start command between LI1 and +24.  If that circuit is open, the drive will not start.

    Please review the installation to ensure starting on power up is safe.  This is the responsibility of the person making these changes.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance