Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    PowerLogic PM8000 series meter custom screens

    Issue
    While setting up the custom screens for the PowerLogic PM8000 series meter, the warning “No compatible registers” is shown when the power meters module is expanded as shown in the screenshot:



    Product Line
    PowerLogic PM8000 series meter

    Environment
    PM8000, ION Setup v3.0

    Cause
    On an older verion of ION Setup v3.0, "Show all registers" might have been selected. This may result in the inability to select a parameter - making it difficult to create a custom screen for the PM8000 series meter.

    Resolution
    Ensure that the system is running the latest version of ION Setup 3.0. (https://schneider-electric.box.com/ionsetuplatest)

    To setup custom screens within the ION Setup Basic Configuration (Setup Assistant):
    1. Run ION Setup, select the PM8000 meter required and open ‘Setup Assistant’.
     
    1. Navigate to the ‘Custom Displays’ tab, select ‘Custom Displays’ and click Edit.

     
    1. The display editor window should appear allowing the user to create or edit screens.
     
     
    1. Select the desired screen and click edit to modify the screen type, parameters and digit display properties.
    1. Within the ‘Step 2: Select Parameters’, click Edit and ensure that “Show all available registers” is unchecked. Expand the measurement type, select the applicable parameter, click OK and Send in the display setup window.


    To setup custom screens within the ION Setup Advanced Configuration:
    1. Right-click on the meter device in the ION Setup window and select properties. Within the device properties window, select the 'Tools' tab and change the 'Device Setup' to 'Show Advanced ION Setup' in the drop-down list and click OK. As a shortcut, you may also hold down the 'CTRL' key and click on the meter.
       
    2. Select the ‘Display Modules’ from the PM8000 modules list and right-click to create a new module within the folder.
       
    3. Each custom screen can display up to 6 parameters. Highlight a source in the Inputs tab and click Edit to select a parameter from one of the modules.
     
    1. Click on the ‘Setup Registers’ tab to adjust the screen title, resolution, number and last digit mode as shown below. Once done, click send.
     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance