Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What is the ohmic tripping value of a PTC probe on an ATV58?

    The motor temperature is detected by PTC probes connected to the ATV58 drive via specific inputs (+10, AI3A, AI3B and COM) on extension card VW3A58201.
     

    The drive's response is as follows:

    At nominal temperature, the resistance measured between terminals AI3A and AI3B must be 1500 ohms, corresponding to a maximum of 6 probes (250 ohms at 20°C) or two sets of 3 (sometimes prewired in the motors).


    The drive detects an OtF fault on the PTC probes if the impedance value measured on the specific inputs is such that Rprobe > 2000 ohm => Uprobe = 1.66 V.

    The OtF motor overheating fault message is triggered indicating that  the motor temperature is too high.

     
    The fault is cleared if the resistance of the probe circuit is such that: Rprobe < 1500 ohm => Uprobe < 1.3 V

    Caution: It is necessary to observe the recommended wiring, as well as the resistance values: R = 10 kohm in series with the probe.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance