Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How to Unlock ATS48 parameters?

    Issue:
     How to Unlock ATS48 parameters?

    Product Line:
     ATS48\

    Environment:
     Unlock parameters

    Cause:
    n/a
     
    Resolution:
    There are two reason why the starter configuration parameters have been blocked.

    1) Customer has enabled a password lock on COD (Terminal locking code). Caution: Before entering a code, do not forget to make a careful note of it.

    The following Information can be found on page 154 of the user manual:

    • OFF: no access locking codes
    - To lock access, enter a code (2 to 999). The display can be incremented using the UP key. Now press ENT. "On" appears on the screen to indicate that the parameters have been locked.
    • On: a code is locking access (2 to 999)
    - To unlock access, enter the code (incrementing the display using the UP key) and press ENT. The code remains on the display and access is unlocked until the next power down. Parameter access will be locked again on the next power-up.
    - If an incorrect code is entered, the display changes to "On" and the parameters remain locked.
    • XXX: parameter access is unlocked (the code remains on the screen).
    - To reactivate locking with the same code when the parameters have been unlocked, return to "On" using the DOWN button then press ENT. "On" appears on the screen to indicate that the parameters have been locked.
    - To lock access with a new code when the parameters have been unlocked, enter a new code (increment the display using the UP or DOWN keys) and press ENT. "On" appears on the screen to indicate that the parameters have been locked.
    - To clear locking when the parameters have been unlocked, return to "OFF" using the DOWN button and press ENT. "OFF" remains on the screen. The parameters are unlocked and will remain unlocked until the next restart.

    If you can't remember the access code please contact Schneider Electric.

    2) The other reason why the ATS48 could be locked is:

    - External display VW3G4801 was connected to ATS48 and ATS48 menu has been locked using mechanical switch on the back side of VW3G4801.
    - Then external display was removed and ATS48 remained locked.

    solve the problem :
    - Connect VW3G4801 to ATS48
    - Unlock mechanical switch on VW3G4801
    - Remove VW3G4801 from ATS48

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance