Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Is it possible to copy the program out of an LMC20 motion controller?

    Yes, it is possible to copy the program out of an LMC20 motion controller.

    There can be instances in which an LMC20 needs to be replaced and the program that is stored inside the LMC20 needs to be copied so that it can be loaded into the replacement LMC20.
    In these instances you will need a software tool known as CodeSys Service tool.

    With the Codesys Service tool, you can upload the boot project from the LMC20 to your PC.
    For this, use the function "File -> Upload" in the Service tool.
    The boot project contains of 2 files:
    1. In the file selection box of the upload function, type manually "DEFAULT.PRG" (in capital letters !!!) and upload it
    2. then, type "DEFAULT.CHK" and upload again.

    The saved files can then be downloaded into the replacement LMC20.


    rev 2/19/18

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance