Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Trace SW turns the generator on but then it turns off right away.

    Trace SW Inverter/Charger is not controlling the generator correctly

    Problem: The Generator start relays are not turning on and off the generator properly
    Solution: Determine whether generator has 2-wire or 3-wire start configuration.
    Ex.(1) If the generator is 2-wire, meaning it starts and runs when wires are connected and shuts off when the wires are disconnected (from each other),  set to Run.  
    RY7 Common and RY7 N.O. (Normally Open) contacts remain closed while generator is running.
    Ex.(2)  If the generator is 3-wire, set to Glowstop, then RY7 remains open while the generator is running. RY8 is used for cranking.
    Refer to relay timing chart on pg.78 of attached manual.
    When the SW loses DC power, the mode goes back to Run by default. 

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance