Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Video: How do you put the ATV12 drive in local mode to run off the face of the drive?

    Issue:
    How do you put the ATV12 drive in local mode to run off the face of the drive?

    Product Line:
    Altivar ATV12

    Environment:
    All

    Cause:
    Requirement to operate the ATV12 in local mode using the wheel for speed control and the start stop buttons for starting and stopping.

    Resolution:

    Programming:
    • Hold the MOD button for 3 to 4 seconds to put this drive in local mode.
    • You will see LOC displayed followed by rdY.
    • While in Local Mode, 3 LEDs will flash top to bottom on the left side of the display to indicate Local Mode is enabled.
    • If you need to go back to remote mode hold the MOD button again for 3 to 5 seconds.
    Please note: If you go between local and remote modes you will reset your logic inputs and CTL FR1 parameters to factory default.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance