in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Powerhouse Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How is a faulted ATS22 reset?

    Issue:
    How is the fault code cleared?

    Product Line:
    Altistart 22

    Environment:
    All models

    Cause:
    The fault code must be cleared to make ATS22 functional.

    Resolution:
    After the condition that created the fault has been corrected, a fault reset can be accomplished several ways:

    1) Remove control power from CL1-CL2. After the display has gone blank, apply control power.
    2) On the integral or remote keypad, press the 3-key combination of ENT / UP arrow / DOWN arrow, simultaneously.
    3) Wire a reset contact to logic input LI2 or LI3 and program it to rSt (remote reset). A momentary contact closure will reset.
    4) Use Modbus command word 752 and write a 1 to bit 3

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance