Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    ATV61 or ATV71: What can cause a drive state of SOC?

    ATV61 or ATV71: Drive state shows SOC

    Product Line:
    ATV61 and ATV71

    All models and serial numbers

    Motor disconnected or motor windings are open.

    SOC is shown as the drive state when a run command is issued and the Fault Management parameter Output Phase Loss is set to "Output cut".  The VFD will remain in this state until an electrical connection is made with the motor.  Then the VFD will begin output to run the motor.  The SOC indicates either the motor is not yet connected or there is a problem with the motor.  Check the motor and motor wiring.  Look for an open contactor or disconnect between the drive and motor.  Close the circuit where appropriate.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance