Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Will the ATS22 display light up with control voltage only?

    Issue:
    Will the ATS22 display light up with control voltage only?

    Product Line:
    ALTISTART 22

    Environment:
    All
     
    Cause:
    Troubleshooting

    Resolution:
    Yes, the HMI should light with control voltage applied.  If the display does not light up:
    Disconnect the remote HMI.
    Verify the correct control voltage is measured at the ATS22 terminals CL1 and CL2
        For models ATS22...S6 and ATS22...Q the control voltage should measure ~230vac
        For models ATS22...S6U the control voltage should measure ~110vac

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance