in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Powerhouse Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What temperature causes the ATS48 to have the Over Heating Fault (OHF) state?

    Issue:
    What can cause an Over Heating Fault (OHF) state on ATS48?

    Product Line:
    ATS48 series soft starters.

    Environment:
    All models, All serial numbers.

    Cause:
    fault condition

    Resolution:
    OHF is triggered in the ATS48 series starters when the heat sink temperature rises above 95 degrees Centigrade (203 degrees Fahrenheit).

    Procedures for remedy
    * Check the mechanism (wear, mechanical play, lubrication, blockages, etc.).
    * Check the sizing of the starter-motor in relation to the mechanical requirement.
    * Check the operation of the fan (if the ATS48 used has one), ensuring that the air passage is not obstructed in any way and the heat sink is clean. Ensure that the mounting recommendations are observed.
    * Wait for the ATS48 to cool before restarting.

    If the temperature is too cold below the Soft starter's environmental specifications, it will trip on OHF.
    For open type ATS48 the temperature ranges are:
    For Operation:  
    14 to +104*F (-10*C to +40*C) without derating
    Up to +140 *F (+60 *C), derate the current by 2% for each *C above 40 *C
    14 to 122 *F (-10*C to +50 *C) with user provided shorting/bypass contactor.
    For Storage:  -13 to +158 *F (-25 to +70 *C)

    For the enclosed units the temperature ranges are:
    For Operation:
    Ambient conditions in installed area from 0 to 40 *C, 32 to 104 *F (Type 1 and 12); 0 to 50 *C, 32 to 122 *F (Type 3R)
    For Storage: -25 to +70 *C, -13 to 158 *F

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance