in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Powerhouse Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What are the basic wiring differences between the ATV58 and the ATV61/71 drives when replacing the drive?

    Issue:
    What are the basic wiring differences between the ATV58 and the ATV61/71 drives when replacing the drive?

    Product Line:
    Altivar ATV58, ATV61, ATV71

    Environment:
    All

    Cause:
    Replacing the old ATV58 drive with a new ATV61 drive. What are the main wiring changes between the two drives?

    Resolution:
    In most cases, the wiring is going to be one to one when you convert the ATV58 over to the ATV61 drives.  It always help if you have the old drawing number for the ATV58 to make sure any HOA controls are programmed correctly when switching over from the old ATV58 to the new ATV61.
    2 wire control is default control on both ATV58 and ATV61 drives.
    LI1 is start FWD on old ATV58 and ATV61.
    +24vdc same on old ATV58 and ATV61
    R1 is the same on the old ATV58 and ATV61
    R2 is the same on the old ATV58 and ATV61
    AI1 on the ATV58 is AI1+ on the new ATV61
    Com is the same on the old ATV58 and new ATV61
    AI2 on the ATV58 is the same on the new ATV61.

    What is new on the ATV61 and ATV71
    There is a jumper wired between +24 and PWR.  This is a factory jumper to satisfy the PWR permissive circuit. Please leave this jumper in place unless you are using the PWR input.
    There is a factory jumper between AI1- and com. Please leave this jumper in place to allow the drives AI1 input to be 0 vdc to 10vdc. If you take out that jumper the AI1 input becomes a bipolar -10vdc to +10vdc input.



     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance